diff --git a/2.9″-TG‐GM29MT1C---ST‐GM29MTF.md b/2.9″-TG‐GM29MT1C---ST‐GM29MTF.md
index 0d53df8..312ef84 100644
--- a/2.9″-TG‐GM29MT1C---ST‐GM29MTF.md
+++ b/2.9″-TG‐GM29MT1C---ST‐GM29MTF.md
@@ -27,4 +27,8 @@ ST-GM29MTF uses the same PCB as TG-GM29MT1C, but without the LED and NFC chip (n
 To program or read-out this tag you have two options:
 
 - Connect BL pin to GND and power on (or reset if already powered on) to enter bootloader mode, then use [cc2538-bsl](https://github.com/JelmerT/cc2538-bsl) to flash firmware via UART.
-- cJTAG or JTAG programmer (J-Link or TI's XDS110), you need to solder the debug pins from the SOC, which is pretty hard for most people.
\ No newline at end of file
+- cJTAG or JTAG programmer (J-Link or TI's XDS110), you need to solder the debug pins from the SOC, which is pretty hard for most people.
+
+# Firmware #
+
+https://github.com/tsl0922/Tag_FW_CC26xx
\ No newline at end of file